Toggle Side Panel
AFRINIC | Learning Hub
AFRINIC | Learning Hub
Close search

Homepage › Forums › IPv6 Learning Lounge › Mastering IPv6 Transition Mechanisms › Implement Manual Tunnelling | IPv4-In-IPv6

Tagged: 

  • samson Mawisire

    Member
    November 26, 2025 at 9:37 am
    200 HPs
    6 QPs
    2719 XPs

    To implement a manual IPv4-in-IPv6 tunnel, configure a tunnel interface on border routers at both ends of the connection, define the tunnel source and destination IPv4 addresses, and set the tunnel mode to ipv6ip. You will also need to configure an IPv6 address on the tunnel interface and set up routes so that traffic destined for the other IPv6 network is directed through the tunnel

Log in to reply.

Start of Discussion
0 of 0 replies June 2018
Now

Report

Harassment or bullying behavior
Contains mature or sensitive content
Contains misleading or false information
Contains abusive or derogatory content
Contains spam, fake content or potential malware

Block Member?

Please confirm you want to block this member.

You will no longer be able to:

  • See blocked member's posts
  • Mention this member in posts
  • Invite this member to groups
  • Message this member
  • Add this member as a connection

Please note: This action will also remove this member from your connections and send a report to the site admin. Please allow a few minutes for this process to complete.

Report

You have already reported this .